BRIDNA PPS600-5 500W Solar Power Generator
- 500W Output
- 512Wh Battery Capacity
- 11 Output Ports for Multiple Devices
- Safe & Stable LiFePO4 Battery
- UPS Seamless Transition
- 120W Solar Charging
- AC/Solar/Car Charing
- 24 + 12 Month Warranty
Instructions for use:
- Run time = 512Wh*90%(conversion rate)/Your device's ower(Watts).
- Support all electronic devices less than 500 Watts.
- It is recommended to use a DC port instead of an AC outlet to power your CPAP machine.
- The usage time for refrigeration machines with compressors mainly depends on the temperature setting and start frequency of compressors, it’s usually lasting longer time than a certain referencetime.
- The above charging times are calculated as a reference guide only. The actual usage time will depend on the power of the connected devices.
Auto-Sleep Mode
To avoid forgetting to turn off the output during use, which will lead to unused battery consumption, this unit will turn to Auto-Sleep Mode when no device is connected or the connected device is less than or equal to a certain value. The unit will automatically shut down after 1 hour. Refer to the table below for more details:
| Output | Output Power | Defaults |
|---|---|---|
| AC Output | ≤2W | The device will automatically shut down after 1 hour |
| USB Output | ≤2W | The device will automatically shut down after 1 hour |
| Car Output | ≤2W | The device will automatically shut down after 1 hour |
| Press any of the port buttons to restart the power station. | ||
| The unit will enter into Auto-Sleep Mode when not output is detected after 1 hour. User can switch the time through the following setting. Set up time to 1 hour or 12 hours by long pressing "USB" button for 5 seconds. Please check the time on the LCD screen within 5 seconds after hearing the buzzer sounds. It shows the set standby time. | ||
| The Auto-Sleep time is 1 hour: If there is no power output within 1 hour, the Auto-Sleep Mode is activated, and the power station will be automatically turned off. | ||
| The Auto-Sleep time is 12 hours: If there is no power output within 12 hours, the Auto-Sleep Mode is activated, and the power station will be automatically turned off. | ||
Precautions
- When the battery capacity drops to 20%, recharge the power station in time to extend the battery life.
- This power station has a built-in lithium battery which is highly sensitive to high temperature - Keep it away from heat sources like direct fire or any heat sources.
- When not using the unit for extended periods of time, power off the unit and disconnect the AC adapter from the outlet.
- Always be prepared - Charge the unit every three months if it is not used, charge the unit to 80% capacity for long-term storage.
- Keep away from moisture or water. Store in a dry and cool place, temperature -20°C~60°C, humidity 20%~85%RH, clean the equipment gently and carefully with a dry cloth.
- Do not disassemble the microwave, puncture, incinerate, or insert foreign objects into the power station.
- Do not stack any objects on top of the device, whether in storage or in use. Do not crush, bend, shred, drop, or place heavy objects on top of the device.
- Do not use the product if damaged or punctured.
Common Troubleshooting
| Failure Description | Types | Solutions |
|---|---|---|
| The unit cannot be charged from AC wall outlets | AC charging fault | 1. Please ensure to use the original AC Power Cord. |
| 2. Please check if the AC wall plug is correctly connected. | ||
| If not solved, please contact our after-sales service. | ||
| The unit cannot be charged from a solar panel | DC solar charging fault | 1. Please ensure the solar charging connection is correct under the user manual. |
| 2. Please ensure the specifications of the connected solar panel meet specified standards. | ||
| 3. Please ensure solar panel charging in a sunlight environment. | ||
| If not solved, please contact our after-sales service. | ||
| LCD Screen icon flash "AC" "DC" "USB" |
Over-current protection | Resolve the problem by pulling out a plug or removing electrical devices. The unit can recover itself after re-start. If not solved, please contact our after-sales service. |
| Short circuit protection | ||
| Over-voltage protection | ||
| Low-voltage protection | ||
| Overload protection | ||
| High-temperature icon continuously appears | High-temperature warning | The power station can recover itself after the battery is cooled. |
Product Specifications
BRIDAN PPS600-5 Portable Power Station
Battery Info
Capacity:512Wh(20Ah/25.6V)
Battery Type:LiFePo4
Life Cycles:2,000+ Cycles to 80% Original Capacity
Shelf-life:Recharge to 80% Every 3-6 Months
Management System:MPPT Controller, BMS, UPS, etc.
Output
AC Output:3 × 120V, 60Hz, 500W
Inverter Type:Pure Sine Wave
Surge Power:1000W
USB-C Port:
1 × PD100W Max (5V3A & 9V3A & 12V3A & 15V3A & 20V5A & PD3.0)
1 × PD27W Max (5V2.4A & 9V3A & 12V2.25A PD3.0)
USB-A Port:
2 × QC24W Max (5V3A & 9V2A & 12V2A QC3.0)
DC Output:
2 × 13.8V/10A Rated Output(DC5521)
1 × Cigarette Lighter+
Input
AC Adapter Input:200W
Solar Input:120W
Car Input:120W
Charging Time
AC Charging(power)
Q:Quick Charging Mode ≈2.5-3.5 Hours
N:Normal Charging Mode ≈4-5 Hours
S:Silent Charging Mode ≈6-8 Hours
DC Car Charging
12VCar Charging≈6-7 Hours
24VCar Charging≈4.5-5.5 Hours
Solar Charging
120WSolar Panel≈6-7 Hours
AC+Solar Charging:≈1.5 Hours
LED Light
Lighting Power:3W Max
Lighting Mode:3 Levels(L/M/H)+SOS
Ceneral
Pass-through Charging:Yes
Weight:14.55lbs / 6.6 kg
Dimensions (LxWxH):11.7 x 7.6 x 7.6 in / 29.7 x 19.5 x 19.5cm
Operating Temperature:14-104℉ / -10-40℃
Storage Temperature:-4-140℉ / -20-60℃
Certifications:
CE-EMC, CE-LVD, ROHS, METI, PSE-EMC, PSE-LVD, IEC, MSDS, UN38.3
Warranty:24-Months
Package Contents
1 × AC Power Cord
1 × DC Car Charger Cable
1 × User Manual
Q:How do I know whether my appliance can work well with the power station?
A:Please check the rated label of your device first. If the device's operating power is within 500W, you can use the device normally.
Q:How long can it run my device?
A:Running time = 512Wh*90%(conversion rate)/Device Rated Power.
Please Note:The formula is NOT suitable for inductive loads with compressors, like refrigerator, air conditioners, etc.
Q:Why is there any sound during use or charging?
A:This product is with intelligent temperature control system. The built-in fans will help the product to get better cooling and securing usage. Slight noise is normal during using or charging.
Q:Can I charge the power station while a device is plugged in?
A:YES.this unit support Pass-Through Charging, you can simultaneously charge other devices while recharging the power station.
Q:Can it be used to jump start a car?
A:NO.it cannot be used to jump start a vehicle
Q:Why does the power station has the Auto-Sleep Mode?
A:To avoid forgetting to turn off the output during use, which will lead to unused battery consumption, this unit will turn to Auto-Sleep Mode when no device is connected or the connected device is less than or equal to a certain value. The unit will automatically shut down after 1 hour.
Q:Is the power station waterproof?
A:NO.please do NOT store it in a humid environment for a long time. Please store it in a dry and cool place
Q:Are the batteries replaceable or upgradeable?
A:NO.Batteries are built in. NOTE-Opening of the unit will void your warranty.